CISCO画面排除区域多边形由 3 组及以上坐标对组成，坐标对之间用逗号分隔。忽略摄像机视野内指定区域出现的人脸
ExcludedArea 配置参数中英对照表
| 英文参数名 | 中文参数名 | 英文配置说明 / 参数值 | 中文配置说明 / 参数值 |
|---|---|---|---|
| ExcludedArea | 画面排除区域 | (0 to 255 characters)（取值范围：0-255 个字符）When set, this configuration instructs the Multi Camera Director to ignore faces that appear in selected areas of a camera's field of view. The format is a list of polygons separated by semicolons. Each polygon is defined by 3 or more coordinate pairs, separated by commas. The coordinates are spherical and expressed in hundredths of degrees. For example, "0,0" would indicate a ray pointing straight out of the camera. "100,100" would indicate a ray pointing one degree to the left and one degree up from the camera. For a motorized camera, the coordinate system is relative to the neutral position of the camera, and does not change when the camera moves. For multi camera setups it is useful to note that the exclusion zones are defined per camera. Example: "1000,500, 500,500, 500,-500, 1000,500; -2000,-1000, -2500,-1000, -2500,-1500, -2000,-1500" This defines two exclusion zones: - The first is from (10°,5°) to (5°,-5°). - The second is from (-20°,-10°) to (-25°,-15°) | (0-255 个字符)配置后，该参数将指示多摄像机控制模块（Multi Camera Director）忽略摄像机视野内指定区域出现的人脸。参数格式为：用分号分隔的多个多边形区域列表，每个多边形由 3 组及以上坐标对组成，坐标对之间用逗号分隔。坐标采用球面坐标系，单位为百分之一度（0.01°）。示例："0,0" 表示摄像机正前方的射线；"100,100" 表示从摄像机视角向左偏移 1°、向上偏移 1° 的射线。对于电动云台摄像机，坐标系以摄像机的初始中立位置为基准，摄像机转动时坐标系保持不变。多摄像机场景注意：排除区域需按单台摄像机分别配置。配置示例："1000,500, 500,500, 500,-500, 1000,500; -2000,-1000, -2500,-1000, -2500,-1500, -2000,-1500"该示例定义两个排除区域：1. 区域 1：坐标范围从 (10°,5°) 到 (5°,-5°) 的多边形区域2. 区域 2：坐标范围从 (-20°,-10°) 到 (-25°,-15°) 的多边形区域 |
需要我将这个摄像机画面排除区域参数补充到全量会议设备配置参数对照表中，形成完整的参数文档吗？